What We Fix
High-end dishwashers are quiet, water-efficient, and tightly integrated into the cabinetry, which is exactly why a failure is frustrating and why the repair calls for care. We work on panel-ready and integrated models from Miele, Bosch, Cove, Thermador, Gaggenau, KitchenAid, and Monogram across Broomfield kitchens, from Cherry Creek remodels to newer builds in the south metro.
Typical repairs include drain pumps, wash pumps and circulation motors, heating elements, water inlet valves, door latches and seals, control boards, and diverter assemblies. If the machine is throwing a fault code, we read it, confirm the cause on the unit rather than trusting the code alone, and replace only the part that has actually failed.
Common Problems We See
- Standing water in the tub. The most common call. Usually a clogged filter or drain pump, a blocked drain hose, or a failed pump motor.
- Leaks onto the floor. Door gaskets, sump seals, and cracked hoses are the usual sources. Left alone, a slow leak reaches hardwood and cabinet toe-kicks.
- Dishes come out dirty or filmy. Clogged spray arms, a worn wash pump, a cold-water fault, or hard-water scale, which builds quickly on Broomfield municipal water.
- Will not start or stops mid-cycle. Door latch switches, control-board faults, or a thermal fault in the heat circuit.
- Long cycles or poor drying. Failed heating element, vent or fan faults, or a thermostat reading out of range.
Typical Causes
Behind those symptoms are a small set of causes. Debris and hard-water scale account for a large share of drainage and wash complaints, and Broomfield water is moderately hard, so scale on the heater and spray arms is worth watching. Mechanical wear on the drain and wash pumps shows up as noise before it becomes a hard failure. Electronic faults on the control board or door switch tend to be all-or-nothing. A good diagnosis separates a simple clog from a failed component so you are not paying for parts you do not need.
Brands We Service
We repair dishwashers from Miele, Bosch, Cove, Thermador, Gaggenau, KitchenAid, Jenn-Air, and Monogram. Each brand reports faults differently, so matching the part and the procedure to the exact model matters.
Common Dishwasher Fault Codes
| Code | Brand | Usual Meaning |
|---|---|---|
E15 | Bosch | Water in the base pan, float tripped, anti-flood active |
E24 | Bosch | Drain fault, clogged filter, pump, or hose |
E22 | Bosch | Filter or drainage blockage, water not clearing |
F11 | Miele | Drain fault, blocked drain path or pump |
F14 | Miele | Water inlet or fill fault |
F70 | Miele | Water-level sensor or float fault |
Dishwasher Acting Up?
Book a visit and we will diagnose it and quote the repair in writing. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
Schedule Service Call Today